While following the build I didn't pay attention to the orientation of the board and set the jumpers on the wrong side of the PCB for one half. I noticed this too late when I had everything else soldered in place, controllers flashed and wanted to connect the two halves.
While it's not a big issue especially for newcomers this could be frustrating since the first thought would be "Now I have to desolder all the switches to fix this".
If you could add a sentence stating that in this case flipping the jumpers on the easily accessible side would be the easiest solution this would be very helpful.
Related Reddit discussion 1
Related Reddit discussion 2
While following the build I didn't pay attention to the orientation of the board and set the jumpers on the wrong side of the PCB for one half. I noticed this too late when I had everything else soldered in place, controllers flashed and wanted to connect the two halves.
While it's not a big issue especially for newcomers this could be frustrating since the first thought would be "Now I have to desolder all the switches to fix this".
If you could add a sentence stating that in this case flipping the jumpers on the easily accessible side would be the easiest solution this would be very helpful.
Related Reddit discussion 1
Related Reddit discussion 2